|
The installment method of
Live Water No.1 on common tap
The matter for attention and step before installment.
please refer to the above figure.
-
First remove the filter at the front end of the original tap.
-
Take out the old rubber cushion pad in the inside.
-
Put two cushion pads on both ends of accessories A.
-
Lock it into the outlet.
-
There is a groove on the bottom of accessories A and uses coin to rotate it.
*such as shown in figure 2.
-
Accessories A have different dimensions. It can be purchased separately if it is unsuitable.
-
After the accessories A is tightly locked, install the main body.
*take out the filter first for easier
installment.Don't forget to install back the filter.
-
Turn it tightly until no water leaking, do not use tool to excessively turn it.
*Note: There is an old type tap that does not need accessories A; it can be directly locked to the tap.
|
|
 |
The installment method of Live Water
NO.1
on old type tap
The matter for attention
and step before installment.
-
Install accessories B
directly into the tap or install the upper part after decomposing
it.
-
Lock the lower part and upper part tightly.
-
Install the main body directly
and does not need accessories A.
-
Similarly, turn it tightly until no water leaking, do not use tool to excessively turn it.
*Note:
The
accessories B should be purchased separately.
|
The tap that is unable to install
*Note:
All non-circular type outlet are unable to install.
|
